When I had my 2015 Jeep Wrangler these were holding on the front plastic grille to the frame.
ixratskrad
All of the vehicles.
StayStrong888
Looks like universal plastic pop rivets for a fender liner or fender flares. I’ve used them on my GMC trucks.
XZIVR
Looks a lot like the ones on my old Subaru.
FlipMyWigBaby
Mazda also uses the ones with the philips head screw design, fender liner and OEM body kit edges. So maybe Japanese cars? I once used the ones without the philips screw head design, and they were a smidgen too short
ClemsonLife2016
“Clears throat”……..magazine!
lordpowpow
I bought a variety pack on Amazon with like 8 different sized clips like these. Surprisingly, my Toyota used about 6 different ones for various panels/ trim pieces.
ikespungler
Damnit clips
erikgeeeee
If it fits, it ships
jnthn1111
Literally any make
Intelligent_Star_516
Most of them.
akmacmac
It looks like a few different ones are in there. I bought the variety pack of these from Harbor Freight and they have been clutch. At first, I was concerned with matching exactly the OE design. Then I realized, as long as the diameter is the same as the OE part, and the length is at least similar, it will work fine (duh). Basically pop it in the hole, and if it feels secure, you’re good to go. They’re not meant to be super precise.
milksteakofcourse
08 Scion tc for sure
762_54r
Every vehicle this is like holding up a handful of nuts and bolts
16 Comments
Retaining clips for plastic body panels
The front end of my Honda has hundreds of them
All of them, and they’re all broken.
When I had my 2015 Jeep Wrangler these were holding on the front plastic grille to the frame.
All of the vehicles.
Looks like universal plastic pop rivets for a fender liner or fender flares. I’ve used them on my GMC trucks.
Looks a lot like the ones on my old Subaru.
Mazda also uses the ones with the philips head screw design, fender liner and OEM body kit edges. So maybe Japanese cars? I once used the ones without the philips screw head design, and they were a smidgen too short
“Clears throat”……..magazine!
I bought a variety pack on Amazon with like 8 different sized clips like these. Surprisingly, my Toyota used about 6 different ones for various panels/ trim pieces.
Damnit clips
If it fits, it ships
Literally any make
Most of them.
It looks like a few different ones are in there. I bought the variety pack of these from Harbor Freight and they have been clutch. At first, I was concerned with matching exactly the OE design. Then I realized, as long as the diameter is the same as the OE part, and the length is at least similar, it will work fine (duh). Basically pop it in the hole, and if it feels secure, you’re good to go. They’re not meant to be super precise.
08 Scion tc for sure
Every vehicle this is like holding up a handful of nuts and bolts