Nut on camber kit is stuck and I’ve sprayed penetrating oil on it but still no results. I’ve been going at it with an adjustable wrench and been trying to do some things to get leverage but it still doesn’t seem to budge.( I don’t have a breaker bar 😣)
by Less_Ad1501
16 Comments
What’s that crack….
Heat and getting the right sized wrench
Pb blast
do you have a jack handle that is hollow? do you have any tanks to heat it ? even if you have one for dabs that could work.
Heat and leverage. Replace that joint though what the fuck
Heat Heat Heat
Soak it with pb or alternative.
Do NOT use an ADJUSTABLE wrench.. you will just round out the bolt.
Bro the fucking wd40 and a hammer. Also need new part for the cracked one. Whatever the hell that is bro..
Might just be the camera angle, but the thread looks bent. Even with the right tools for the job it may not come undone with non-destructive methods.
adjustable wrench is your problem. get the right size and a cheater bar if possible
call it quits til you come back with the proper wrench.
STOP right now and replace that knuckle. Actually, stop right now and take it to a shop. If your expertise doesn’t cover removing frozen nuts/bolts it sure doesn’t cover replacing a knuckle
If you heat it, make sure you aren’t torching anything flammable like the gas tank. I’m too scared to heat. I get most things with penetrating oil and breaker bar. Sometimes I hit the wrench with my sledge hammer. And it probably won’t work in this case, but if you can get a wrench under or between a jack, you can use the jack to turn the wrench handle.
That looks to be reverse thread
Heat. Torch that bitch red hot and try again.